Aptiv Automotive Connector 3D STEP Models
Provider:Aptiv
Aptiv serves 3D STEP models for automotive sealed and high-speed connectors by part number via its product pages, for vehicle and harness twins.
At a glance
- Readiness
- L1 · Rigid-body ready
- Rationale
- Product pages and portals provide to-scale 3D models (STEP among them) and ECAD/CAx data, with extractable mass and collision geometry, hence L1; the assets are component exterior geometry and electrical-connectivity definitions, with no material parameters for EM, thermal or contact-mechanics simulation.
- Scale
- Covers the full line of automotive sealed connectors, high-speed data connectors, terminals and inserts; product-page 3D Model sections serve STEP models by part number. (The part-number lookup and STEP download in the product-page 3D Model section follow Aptiv’s official product-page structure; no single-vendor model count is published, so coverage is stated by product line and page. Checked 2026-11-01.)
- License
- Proprietary but free — 3D CAD data are free for product design; the intellectual property belongs to Aptiv and may not be redistributed or used outside design. The models are exterior geometry; current rating and contact resistance must come from the official technical datasheets.
- Access
- Open
- Formats
- step · iges · other · dict
- Runtimes
- other
- Physics properties
- Collision geometryMass / inertiaElectrical
- Domain
- Electromagnetics / Power · Solid / Structure
- Published
- 2026-11-01
- Updated
- 2026-11-06
Why it is listed
Aptiv is a major automotive electrical-architecture and connector supplier — the sealed and high-speed connectors behind modern vehicles. For a vehicle or harness twin, its connector geometry is what the 3D routing model needs, served from the vendor’s own product pages.
Readiness assessment
Aptiv product pages serve 3D STEP models per connector part number, giving rigid-body geometry with extractable mass and collision shells — that is L1. The assets are connector housing geometry; they carry no material parameters for EM or thermal simulation, and current/contact ratings must come from the datasheet.
Practical notes
On a product page, open the 3D Model section and download the STEP file for the specific connector. For a harness layout, model the connector body at each end and route the bundle between them. Current and contact ratings are in the product drawing, not the mesh.
Disclaimer: license and usage terms follow the official source — verify them yourself before use. This site indexes and links only; it does not host or mirror any asset file.
License and usage terms are those of the official source — verify before use. No asset file is hosted or mirrored on this site.